Technical Specifications

Performance Features

Fan airflow capacities from 310 to 1550 CFM

Primary airflow capacities from 52 to 1430 CFM

Available in 4 sizes

20 gage, galvanized steel casing construction

Suitable for low, medium, or high pressure applications

Linear, multiple-point, averaging velocity sensor with an amplified signal

Damper blade has a flexible gasket for tight airflow shutoff

Damper blade operates over a full 90 degrees

All damper assemblies utilize a solid ½ in. shaft that rotates in self lubricating Delrin® bearings

Pressure independent controls, including Carrier i-Vu Open (BACnet), Carrier Comfort Network® (CCN), analog, or pneumatic controls

Electric or hot water reheat coils

Multiple casing liners available

Electric heat (1 to 3 stages) or proportional heat

Unit casing lined with ½ in. thick, 1-1/2 lb dual density fiberglass insulation that meets UL 181 and NFPA 90A

Certified performance in accordance with ARI Standard 880

Reliability Features

20 gage, galvanized steel heaters are ETL listed in accordance with UL standards

Heaters equipped with:

Primary automatic and secondary manual reset thermal cutout

Deenergizing magnetic contactors

Airflow proving switch

80/20 Ni-Cr elements

Strong integral panel/post construction for product durability

Maintenance Features

NEMA 2 steel control enclosure for electric or electronic components

Removable bottom access panel for easy accessibility during routine inspections and maintenance

Label information adhered to each unit includes model, size, airflow (cfm), balancing chart, and tagging data

Installation Features

Rectangular discharge with slip and drive connections provides quick and easy connection to downstream ductwork

10-5/8 in. high unit casing accommodates installation in reduced ceiling plenum space

Factory-installed controls

All round collars accommodate standard spiral and flex duct sizes

Balancing taps provided for easy airflow verification

Single point electrical connection

Standard Warranty

One-year parts

Factory-Installed Options

Control options: Analog electronic controls, Carrier i-Vu Open VAV or VVT Controls, Carrier Comfort Network (CCN) VAV or VVT Controls, Pneumatic controls, No controls or field-supplied DDC (direct digital controls) third party controls for factory mounting

Left-hand or right-hand control enclosure (dust-tight)

Hanger brackets

Hot water coils (1 or 2 rows)

Liner options: 1 in. thick, dual density fiberglass, Cellular, Foil encapsulated fiberglass, None

Cam locks (bottom access panel)

Vent and drain on water coils

Electric heat (1 to 3 stages)

Proportional SSR (solid-state relays) electric heat

Electric heater options: Fused door interlocking disconnect switch, Non-fused door interlocking disconnect switch, Mercury contactors, Fuse block with fuses for primary overload protection, Dust-tight construction

Motor fusing

Recirculated air filter

ECM (electronically commutated motor) motors

Field-Installed Accessories

CO₂ sensors for advanced air quality monitoring

Remote wall and supply-air temperature sensors for precise zone control